Adjusted output levels will be stored and will be active the next 9Info time you boot the Loudness Maximizer. If you recognize that your
unit does not maximize to full scale, please check the Output Level parameter first.
The Output Level attenuation is not shown in the Output PPM meters!
Tip: The Output Level should only be used where the output signal should permanently be lower than 0dB.
The Output Level setting will be ignored when a MIDI volume change command is present. MIDI has first priority. Note that the setting in the Output Level page will still show the reduced output level, nevertheless, a MIDI volume change command may already have reset the output level to a different value. Therefore, if you use MIDI set Output Level to 0dB.
You leave the INFO pages by depressing STORE.
L o u d n e s s M a x i m i z e r | 17 |
