Presets | 8 | The Loudness Maximizer allows you to store up to 99 presets, |
|
| which can be changed by MIDI program change command. |
Storing a preset: |
| If you want to store a new adjustment, depress Store for one |
Depress Store for1 sec. – |
| second. The LED starts to flash indicating that the Store mode has |
LED flashes; |
| been activated. The |
use Up/Down to select |
| presets (including the BOOST function) before the Loudness |
preset number; |
| Maximizer was switched off the last time. Use Up and Down to |
depress Store again – |
| select a new preset number.The |
LED goes out,preset is stored |
| cate that the input (depressing Up or Down) is accepted. Keeping |
|
| Up or Down depressed will let you jump through the preset list in |
|
| steps of 5 presets. Once a new preset location is found depress |
|
| Store again. The Store LED goes out. The preset is stored at the |
|
| new location. |
|
| In case you want to quit the Store mode without storing the |
|
| new adjustments simply press Apply. |
Applying a preset: |
| If you want to apply various presets depress Apply for one |
Depress Apply for1 sec – |
| second. The Apply LED starts to flash indicating that the Apply |
LED flashes; |
| mode is activated. You can step through the preset list with Up |
use Up/Down to select |
| and Down. Once you have a preset that you want to apply depress |
preset number; |
| Apply again. The Apply LED goes out indicating that the preset is |
depress Apply again – |
| applied. |
LED goes out,preset is applied |
|
|
In case you want to quit the Apply mode without applying the new preset simply press Store.
Operation safety:
Presets can not be changed by accident
Info
12
To increase operation safety it is impossible to apply presets by simply depressing Up or Down.The Up and Down
9 Depressing Store and Apply simultanouesly for about one second gets you into a hardware dialogue, called INFO. The LC- display shows status informations of the digital data stream. With Up/Down you will jump from one page to the next or previous. If a selection is provided use Apply to select.
