Sound Performance Lab 9737 manual Presets

The DRIVE LEVEL metering shows the recording level of the “virtual tape machine”. The display range is -10dB to +21dB. The DRIVE LEVEL ist adjusted with the DIRVE control (see 3).

The OUTPUT PPM meters show the peak level after the OUTPUT

GAIN control (see 5).

The first LED in each INPUT and OUTPUT PPM meter is a signal (SIG.) LED to indicate that a valid digital source is connected and detected. This LED helps you to verify the signal flow within a digital processing chain. If one SIG. LED is not illuminating you have a first indication of a faulty digital signal flow.

The last LED of each INPUT and OUTPUT PPM meter is a CLIP LED. The LED illuminates if the digital signal is too hot causing digital distortion.

The MACHINE HEAD allows you to store up to 99 presets, which	9		Presets
can be changed by MIDI program change command.
If you want to store a new adjustment, depress STORE for one		Storing a preset:
second. The LED starts to flash indicating that the STORE mode
has been activated. The LC-display now shows the values of the		Depress STORE for1 sec.,
presets (including the BOOST function) before the MACHINE HEAD
		LED flashes;
was switched off the last time. Use UP and DOWN to select a
		use UP/DOWN to select
new preset number. The status-LED flashes shortly to indicate
		preset no.;
that the input (depressing UP or DOWN) is accepted. Keeping UP
		depress STORE again,
or DOWN depressed will let you jump through the preset list in
		LED goes out, preset is
steps of 5 presets. Once a new preset location is found depress
		stored
STORE again. The STORE LED goes out. The preset is stored at the
new location.
In case you want to quit the STORE mode without storing the
new adjustments simply press APPLY.
If you want to apply various presets depress APPLY for one		Applying a preset:
second. The APPLY LED starts to flash indicating that the APPLY
mode is activated. You can step through the preset list with UP		Depress APPLY for1 sec.,
and DOWN. Once you have a preset that you want to apply		LED flashes;
depress APPLY again. The APPLY LED goes out indicating that the		use UP/DOWN to select
preset is applied.		preset no.;
In case you want to quit the APPLY mode without applying the		depress APPLY again,
new preset simply press STORE.		LED goes out, preset is
		applied
NOTE: To increase operation safety it is impossible to apply		Operation safety:
presets by simply depressing UP or DOWN. The UP and DOWN		Presets can not be changed
status-LEDs will not flash indicating that the input is not		by accident
accepted. You have to depress STORE or APPLY for one second in
order to activate the UP and DOWN buttons.

Control Elements

Machine Head 11