Effect Start Sync, Applying the BPM-FX | SoundCraft 1601E manual

EFFECT START SYNC

The effect sync (LFO waveform) will re-trigger every time any of the following occurs:

the BPM FX Mix fader is moved away from the [original] position, either of the BPM FX switches is moved to its [on] position,

or

the selected effect button (1-5) is pressed.

Applying the BPM-FX

If the BPM-FX switch on either of the input channels is set to the ON position, the effects will be applied to that input channel.

If both switches are set to ON, the bpm-fx effects will be applied to the master output.

35

Image 35

SoundCraft 1601E manual Effect Start Sync, Applying the BPM-FX

Contents

Page Potters BAR Contents Important Safety Instructions Green and Yellow US Green/Yellow Recommended Headphone Impedance = 200 Ohms Safety Symbol GuideHeadphones Safety Warning TIP BPM Effects IntroductionPage Mains Installation InstallationGeneral Precautions Shielding Initial Wiring ConsiderationsAudio Wiring Working Safely with Sound Points to Remember Environmental Considerations Inspection and InstallationPowering Unpacking and Inspection Connecting to a Typical Sound System Replacing The Faders Making Adjustments and Fitting SparesSetting The Pre-trim Pads Changing The Orientation Of The Phono/Line SwitchesPage TOP Panel Description BPM FX MIX Fader BPM FX Section see Balanced Booth Outputs -XLR Connectors Rear Connector PanelBalanced Master Outputs -XLR Connectors EQ CUT -Rotary Front Panel MIC / Line Input Combi -XLR ConnectorOperation Getting Started MIC Insert Socket rearcon Level ControlEQ -LOW Control EQ -HIGH Control PRE-TRIM Pads Input Selector SwitchesClip Indicators MID EQ Channel Volume FadersTrim HI EQ Send -SELECT FX Send & Return / AUXSend -LEVEL Record OUT Return / AUX -LEVEL Clip IndicatorFX ON/OFF Switch FX SEND/RETURN RE-CONFIGURATION Master / Booth Output Fader Curve FaderExciter Headphone Sockets Headphone MonitorLevel MASTER/CUE Select Monitor Operating Criteria Bank ModeBeats Indicator BPM FX Module Y Controls TAP/CLEARIsolator BPM FX MIX ON-OFF switches Activating the Effects Setting UPQuick Start Connections TAP -Tempo Edit OperationBPM Range TAP/CLEAR Button Applying the BPM-FX Effect Start Sync Rotary Encoder Effect ControlsMIX Fader Band Isolator Single Mode SINGLE/MULTI Mode OperationMode Bank select Program Edit and Recall Multi ModeAdditional speed settings for FILTER/FLANGER/PANNER Frequency EffectsFilter SUB-MENU Repeats Y DelaySpeed WAY Split Y PANSPS Slope Y CutterDepth X mark space ratio Depth Y FlangeResonance is factory set @ 75% Hints & Tips PRE-SET Voice List Block Diagram Connecting Leads Troubleshooting Specifications Warranty Post after the channel fader Glossary Equalising the system to notch out the offending frequencies Riaa