HEADPHONE MONITOR

This section of the mixer features all the headphone monitoring controls which, again, come under the control of the DSP. This allows the inclusion of a special cue EQ control which filters-out unwanted frequencies, letting you tune-in to defined elements within the sound and create a perfect mix.

LEVEL

This control adjusts the output level to the connected headphones. At the fully anti-clockwise position there will be no sound. As the control is moved in a clockwise direction the output level will be gradually increased until, at the fully clockwise position, the output level will be at its maximum.

MASTER/CUE SELECT

This switch selects the monitor signal source. When the switch is at [MASTER], the monitor output sound will be derived from the master output bus. When the switch is at [CUE], the monitored sound will be derived from the [XF MONITOR].

Note: when this switch is set to [MASTER], the headphones will be post-eq; when it is set to [CUE], the headphones will be pre-eq.

EQ

This control adjusts the tone of the monitored sound, cutting the highs or lows about the centre off position. At the 12 o’clock centre position the EQ will be flat (no cut). As the control is moved clockwise the HIGHER frequencies will be progressively cut until, at the fully clockwise position the maximum high frequency cut will be applied (-85dB). As the control is moved anti-clockwise from the centre position the LOWER frequencies will be progressively cut until, at the fully anti-clockwise position the maximum low frequency cut will be applied (-85dB). NOTE: fully clockwise=dark, fully anti-clockwise=bright.

28

Page 28
Image 28
SoundCraft 1601S manual Headphone Monitor, Level, MASTER/CUE Select