COUNTER GRIDDLE INSTALLATION
OPERATOR’S MANUAL 1182629 REV 2PAGE 13
INSTALLATION
Step 2e: Installation on Floor Stand (60" Models)A 60" griddle may be installed on top of an optional floor stand (for 24", 36", and 48" griddles, g o to Step 2d
on page 11). The floor stand is shipped in a separate crate and must be assembled, as follows:
1. Position the bottom-brace pieces on a flat surface, as shown in Fi gure 8 b elow. There ar e four bo ttom-
side braces (items “A”), and four front/rear bottom-braces ( items “B”).
2. Position a corner brace (item “C”) in each interior corner, matching the pre-punc hed holes on the lo wer
inside flange of the bottom braces.
3. Position the six leg brackets (item “D”); one in each corner of the stand, one front-center, and one rear-
center, as shown in Figure 8. Be sure that the bracket flanges are engaged into the o pen hem of the
bottom braces.
4. Use the thirty-two 1/2"-long hex head bolts (items “E”), lock washers (items “F”), and acorn nuts (it ems
“G”) to bolt the corner braces to the bottom braces. Only hand-ti ghten for now.
5. Check that the leg brackets are in the proper position, and tha t the outside corners are square.