Southbend Step 2d: Installation on Floor Stand (24", 36", and 48" Models)

COUNTER GRIDDLE INSTALLATION
OPERATOR’S MANUAL 1182629 REV 2PAGE 11
INSTALLATION
Step 2d: Installation on Floor Stand (24", 36", and 48" Models)
The 24", 36", and 48" griddles may be installed on to p of an opt ional f loor stan d (for 60" grid dles, go to Step
2e on page 13). The floor stand is shipped in a separate c rate and must be assembled, as follows:
1. Position the bottom-brace pieces on a flat surface, as shown in Figure 6 be low. There ar e two bottom -
side braces (items “A”), a bottom-front brace (item “B”), and an identical bottom-rear brace (item “B”).
2. Position a corner brace (item “C”) in each corner, matching the pre-punched hol es on the lower inside
flange of the bottom braces.
3. Position a leg bracket (item “D”) into each corner. Be sure that the br ack et f langes are en gaged into the
open hem of the bottom braces.
4. Use the sixteen 1/2"-long hex head bolts (items “E”), lock washers (items “F”), and acorn nuts (it em s “G”)
to bolt the corner braces to the bottom braces. Only hand-tight en for now.
5. Check that the leg brackets are in the proper position, and tha t the outside corners are square.
Figure 6
G
F
E
A
D
C
B
D
C
A
6. Use the eight 1-1/2" hex bolts (items “H” in Figure 7) to attach the two left-legs (items “I”) and the two
right-legs (items “J”). “Left” and “right” are as seen from the front or rear of the stand. Be sure that the
small threaded-insert near the top of each leg faces either the front or the re ar of the stand, not a side.
Insert the bolts through the leg brackets and into the legs. On ly hand-tighten the bolts for now.