Installation
AM
Replace the batteries when the
Battery Low Indicator
appears on the LCD display.
USING THE PHONE ON A DESK
a.Plug the long telephone line cord into the jack in the bottom of the BASE. Thread it through the groove toward the back of the unit, and then plug it into the modular wall jack.
b.Connect the COIL CORD to the jack in the HANDSET and the BASE.
Installation
b.Install the long telephone line cord into the jack in the BASE. Thread it through the groove, and plug it into the modular wall jack as shown.
c.Hang the base on the screws and pull it down to lock it on.
d.Plug the COIL CORD into the HANDSET and BASE jacks.
HANGING THE PHONE ON THE WALL
When the FM2560 is
ON A WALL PHONE PLATE:
a. Plug the short telephone line cord into the jack in the Base bottom and into the jack on the plate.
b. Hang the BASE on the two pins and push the BASE down to lock it on.
c. Plug the COIL CORD into the HANDSET and BASE jacks.
ON THE WALL WITHOUT A PLATE:
a. Install 2 screws with anchors into the wall, one above the other,
10
Setting Up Your FM2560
NOTE: Do not lift the handset until you are finished setting the Caller ID information.
To Set Language
1.If "SET LANGUAGE" is not already displayed on the screen, press and hold the REDIAL Button (on the back of the
handset) for 2 seconds. The LCD display will then show "SET LANGUAGE ▲ ▼".
2. Press the REVIEW ▲ or ▼ Button to select English, French or Spanish.
3. Press the ERASE Button
to confirm the language selected. The unit will then proceed to the contrast setting mode.
To Set LCD Display Contrast
1.Press the REVIEW ▲ button to make the contrast darker or the REVIEW ▼ button to make the contrast lighter.
11