Step 5. Select the CPU Burst Mode (J1)
There are two types of CPU burst modes according to manufacturer design:
Ø | Interleave Burst | (CPU: Intel P54C/P55C, AMD | |||||||
| X86 CPU, Rise mP6) |
|
|
|
|
|
| ||
Ø | Linear Mode | (CPU: Cyrix 6x86/L/MX/M¢ )º |
|
|
| ||||
|
|
|
|
|
|
|
|
|
|
|
|
| Interleave |
|
| Linear |
|
|
|
|
|
|
|
|
|
|
|
| |
CPU Burst Mode | Intel® P54C/P55C |
|
|
|
|
|
| ||
AMD ™ |
| Cyrix ™ 6x86/L/MX/M¢ º | |||||||
|
|
| |||||||
|
| IDT X86 CPU, Rise mP6 |
|
|
|
|
| ||
J1 Setting | When using Intel | 1 |
| When using |
|
| 1 | ||
|
|
| |||||||
or AMD CPUs. |
| Cyrix type of |
|
| |||||
2 |
|
|
| 2 | |||||
|
|
|
|
| CPU. |
|
| ||
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
If you are using a Cyrix ™ 6x86/L/MX/M II series CPU, set the burst mode to Linear by shorting jumper J1, and follow the following steps to select the correct Linear burst mode in BIOS:
1.During the
2.Select the [CHIPSET FEATURES SETUP] section in BIOS.
3.In the [CHIPSET FEATURES SETUP]
4.Press [Esc] to return to the BIOS main menu.
5.Then choose [Save & Exit Setup] to
Step 6. Configure Memory
Your board comes with three DIMM sockets, providing support for up to 768MB of main memory using DIMM modules from 8MB to 256MB. For 66/75MHz host bus CPUs use 12ns or faster DIMM modules.
Memory Configuration Table
MEMORY |
| DIMM Banks |
| |
CONFIGURATION | DIMM 1 | DIMM 2 | DIMM 3 | |
| ||||
RAM Type | SDRAM | SDRAM | SDRAM | |
|
|
|
| |
Single RAM | 8/16/32/64/128/256 | 8/16/32/64/128/256 | 8/16/32/64/128/256 | |
Module Size (MB) | ||||
|
|
|
Note: If you plan on using the onboard VGA and intend to install only one DRAM module, then this single DRAM must be installed in bank DIMM 1.
Hardware | Installation |
|
|
11
