SOYO SY-6IEB Configure Memory, Set the CPU Frequency, Enable/Disable the Keyboard Wake-Up JP10

Hardware Installation

SY-6IEBQuick Start Guide

Step 3. Configure Memory

Your board comes with two DIMM sockets, providing support for up to 256MB of main memory using DIMM modules from 8MB to 128MB with no restriction on memory configuration. Therefore, you can install memory modules in any combination.

Memory Configuration

MEMORY		DIMM Banks
CONFIGURATION	DIMM 1		DIMM 2
RAM Type	EDO/SDRAM		EDO/SDRAM
RAM Module Size (MB)	8/16/32/64/128		8/16/32/64/128

Note : There are two types of DIMM modules with different operating voltages: 3.3V and 5.0V. Please note that only 3.3V EDO DIMM modules can be used on this Motherboard.

Step 4. Set the CPU Frequency

You do not need to set any jumper for the CPU frequency. Instead, CPU settings are changed through the BIOS [SOYO COMBO SETUP]. Please refer to Chapter 3 - Quick BIOS Setup for details on how to set the Pentium® II processor frequency.

Step 5. Enable/Disable the Keyboard Wake-Up (JP10)

You can choose to enable the Wake-Up by Keyboard or Mouse function by shorting pin 1-2 on jumper JP1, otherwise, short pin 2-3 to disable this function.

Support Wake-Up

by Keyboard

EnableDisable

JP10 Setting	Enable Wake-up	Disable Wake-up
	by Keyboard	by Keyboard
	function	1 2 3 function	1 2 3
	(short pin 1-2)	(short pin 2-3)

Important: When using the Keyboard Wake-Up function, please make sure the ATX power supply can take at least 720mA load on the 5V Standby lead (5VSB) to meet the standard ATX specifications.

8