![](/images/new-backgrounds/1148871/14887191x1.webp)
Hardware Installation |
|
Step 3. CNR MR
CNR MR Card- | Primary |
| Secondary |
|
CODEC OPTION |
|
| ||
|
|
|
| |
JP8 Setting | open JP8 |
| Short JP8 |
|
| 1 | 2 | 1 | 2 |
Step 4. Set JP9 for FWH Boot Block
Setting this jumper to open will prevent the boot block area of the FWH (FirmWare Hub) chip from being written data into such that it is write- protected from unwanted or abnormal write activity.
Note: In some rare cases, the boot block area will need to be flashed to complete the BIOS upgrade procedure. Setting JP9 to open will cause incomplete BIOS update in that case.
The FWH BootLockedUnlocked Block
JP9 Setting
Open JP9
Short JP9
1 2
1 2
Step 5. SPEAKER OPTION (JP22)
Through this jumper the case speaker output can be redirected to the
external (amplified) speakers (if connected) through the
Codec. |
|
|
|
|
|
|
SPEAKER OPTION | Lineout SPK |
| CASE SPK |
|
| |
JP22 Setting | Short pin |
|
| Short pin |
|
|
| 1 | 2 | 3 | 1 | 2 | 3 |
| 42 |
|
|
|
|
|