Hardware Installation SY-7ISA+
45
2-3.7 Power On
You have now completed the hardware installation of your Motherboard
successfully.
1. Turn the power on
2. To enter the BIOS Setup Utility, press the <DEL> key while the system
is performing the diagnostic checks,
Note: If you have failed to enter the BIOS, wait until the boot up
sequence is completed. Then push the RESET button and press
<DEL> key again at the beginning of boot-up, during diagnostic
checks.
Repeat this operation until you get the following screen.
3. The BIOS Setup screen appears:
CMOS Setup Utility – Copyright ( C ) 1984-2000 Award Software
4Soyo Combo Feature 4PC Health Status
4Standard CMOS Features Load Fail - Safe Defaults
4Advanced BIOS Features Load Optimized Defaults
4Advanced Chipset Features Set Supervisor Password
4Integrated Peripherals Set User Password
4Power Management Setup Save & Exit Setup
4PnP/PCI Configurations Exit Without Saving
Esc : Quit áâàß : Select Item
F10 : Save & Exit Setup
Change CPU’s Clock & Voltage