¡Note:° The STR LED is connected to the Voltage that feeds the DIMM sockets. Therefore the following table applies:
| Suspend to RAM | Normal Operation | Power Off |
STR LED | ON | ON | OFF |
Step 3. Configure Memory
Your board comes with three DIMM sockets, providing support for up to 1.5GB of main memory using unbuffered and registered DIMM modules from 8MB to 512MB. On this motherboard, DRAM speed can be set independent from the CPU front side bus speed. Depending on the DRAM clock speed setting in the BIOS setup, appropriate memory modules must be used. For 66MHz DRAM speed, use PC66 memory; for 100MHz DRAM speed, use PC100 memory; for 133MHz DRAM speed, use PC133 memory.
Memory Configuration Table
Hardware | Installation |
|
|
Number of
Memory Modules
RAM Type
Memory Module
Size (MB)
DIMM 1 |
| DIMM 2 |
| DIMM 3 |
|
|
|
|
|
SDRAM / VCM SDRAM
8/16/32/64/128/256/512 MB
Note:Always install memory modules in the order prescribed in this table.
CMOS Clear (JP5)
In some cases the CMOS memory may contain wrong data, follow the steps below to clear CMOS memory.
1.Clear the CMOS memory by momentarily shorting pin
2.Then put the jumper back to
CMOS Clearing
JP5 Setting
Clear CMOS Data
Short pin 2-3 for
at least 5 seconds to
clear the CMOS
1 2 3
Retain CMOS Data
Short pin 1-2 to
retain new settings
1 2 3
Note: You must unplug the ATX power cable from the ATX power connector when performing the CMOS Clear operation.
9
