Specialized CylcoComputer manual Installing the Battery, Troubleshooting, Display is blank

Models: CylcoComputer

1 12
Download 12 pages 3.31 Kb
Page 10
Image 10

Clock

Your SpeedZone® Elite is equipped with a digital clock, which is accessed by pressing the "MODE" button for three seconds. The clock can be set to operate in either 12 or 24-hour mode.

Second Wheel Mode

For riders who own more than one bicycle or who frequently change tires, the SpeedZone® Elite is capable of storing two tire sizes. You can change between the two sized by pressing both the "MODE" and "FUNCTION" buttons simultaneously for three seconds. The second wheel mode indicator will change from 1 to 2. Mileage recorded will be cumulative between the two sizes. (An accessory handlebar mount is available from your Specialized dealer)

18

FIGURE 18: BATTERY INSTALLATION

INSTALLING THE BATTERY

Your SpeedZone® Elite Computer comes with the battery installed at the factory. Should you need to replace the battery, push the computer backward to remove it from the handlebar mount. Before removing the battery make a note of your odometer reading and wheel circumference settings so that you can

re-enter them when you restart the computer. Turn the computer over so the display is facing downward. Use a coin to unthread the battery cap from the computer. Install the battery (model CR2302) with the positive pole (+) facing upward. Carefully thread the battery cap back onto the case with a coin. (See Figure 18)

If the LCD display is blank or shows incomplete digits, turn the computer over and press the "AC" button on the bottom of the case with the tip of a pen or a paper clip. This will clear all the data and re-start the computer. Reinstall the computer by pushing it forward into the mount until it snaps into place.

TROUBLESHOOTING

Display is blank:

Change the battery or press the AC button on the bottom of the case

Display shows partial digits: Press the AC button on the bottom of the case.

Speed/distance not recording: Check sensor/magnet alignment. Make sure that the sensor is no more than 1/16" (2mm) from the magnet.

Entire screen is dark:

Did you leave the bike parked in the hot direct sun when it was parked? If so, move the bike to the shade. The data will be OK.

Computer moves on handlebar: Tighten mount or add sizing straps to improve fit on handlebar.

19

Page 10
Image 10
Specialized CylcoComputer manual Installing the Battery, Troubleshooting, Display is blank, Entire screen is dark