Specialized Enduro 6, Demo 8 manual DEMO 7 FRAME GEOMETRY

DEMO 7 FRAME GEOMETRY

		Small		Medium		Large
1	*Top Tube Length	550mm	21.65”	575mm	22.64”	595mm	23.43”
2	**Standover Height	748mm	29.45”	753mm	29.65”	763mm	30.04”
3	Head Tube Length	120mm	4.72”	120mm	4.72”	120mm	4.72”
4	Head Angle - Steep	66°	66°	66°	66°	66°	65°
4	Head Angle - Slack	65°	65°	65°	65°	65°	64°
5	Seat Angle - Steep	66°	66°	66°	66°	66°	66°
5	Seat Angle - Slack	65°	65°	65°	65°	65°	65°
6	BB Height - High	374mm	14.72”	374mm	14.72”	374mm	14.72”
6	BB Height - Low	362mm	14.25”	362mm	14.25”	362mm	14.25”
7	Wheelbase	1160mm	45.67”	1185mm	46.65”	1205mm	47.44”
8	Chainstay Length	421mm	16.57”	421mm	16.57”	421mm	16.57”

*TT length is the Horizontal Measurement from the center-line of the HT at the top of the HT to the center-line of the projected seat tube.

**Stand Over height is measured vertically at the centerpoint of the TT measurement.

FRAME SPECIFICATIONS

Head tube: 1.5”
Seatpost: 30.9mm
Front derailleur clamp: 34.9mm
Rear hub spacing: 135mm (6mm Drive-Side offset)
BB shell: 73mm
Seat Collar: 34.9mm			NOTE: Stock setting for the shock stroke is 2.375”, resulting in 7.3” of travel.
Stroke: 60.3mm / 63.5mm (2.375” / 2.5”)			Travel can be increased to 7.7” by removing the small travel limiting chip
Eye-To-Eye: 215.9mm (8.5”)			located under the bottom-out bumper on the shock shaft.
Travel: 7.3” / 7.7”			When increasing travel, it’s recommended to reduce spring preload, or drop
Sag: 30-35% (18-21mm / 19-22mm of stroke)			to the next lower spring rate to keep the recommended sag percentage.
SIZE	SPRING RATE	RIDER WEIGHT	NOTE: Spring weights listed are to be used as an adjustment starting point
			only. Rider weight and riding style may require a different spring rate than
Small	400lb	<150lb	the stock spring rate. Replace the spring accordingly. Refer to your shock
Medium	450lb	150-185lb	manufacturer’s manual for additional shock setup information.
Large	500lb	185-220lb

11