Speed Queen LES37A*F 19

1.Remove access cover from rear of dryer.

2.Use a strain relief and insert end of power cord through power supply hole.

3.Use the three screws from the envelope located in the cylinder to attach the power cord wires to the terminal block.

4.Tighten all screws and reinstall access cover removed in step 1.

Installation

D286I

1“L1” Terminal

2Neutral Terminal

3“L2” Terminal

Figure 9

510988

Contents

Keep These Instructions for Future Reference www.comlaundry.com Page Page Notes Table of Contents Page Replacement Parts Page Safety Information Page Installation Step 1: Position and Level the Dryer Step 2: Connect Dryer Exhaust System Step 3: Connect Electrical Cord Step 4: Wipe Out Inside of Dryer Step 5: Connect the Dryer to Electrical Power Reversing Door Procedure 240 Volt, 60 Hertz, 2-Wire Plus Grounded (Earth) Wire Installation Page 240 Volt, 60 Hertz, 3-Wire Page Location Requirements Exhaust System Materials Make-UpAir Requirements Exhaust Direction Exhaust System Dryer Airflow Page Operation Energy Saving Tips Helps and Hints Load Automatic Regular/Delicate Cycle Time Dry Cycle Automatic Permanent Press/Knits Cycle To Dry Clothes IMPORTANT: Refer to the INSTALLATION INSTRUCTIONS before using dryer End of Cycle Signal Optional Equipment Maintenance Dryer Interior Cabinet Control Panel Motor Overload Protector Lint Filter Before You Call for Service If the Dryer: Won’t Doesn’t Dry Clothes If Service Is Required Information for Handy Reference