Spirit 1776 Power Supply, Radio Operation, Battery supply, Mains supply, Radio aerials

Models: 1776

1 11
Download 11 pages 44.91 Kb
Page 5
Image 5
POWER SUPPLY

POWER SUPPLY

Battery supply

• Open the battery compartment and insert as shown 8 batteries, type R14, UM2 or C-cells.

Remove the batteries if exhausted or if they will not be used again for a long period.

*The battery supply is switched off when the set is connected to the mains.

To change over to battery supply, pull out the plug from the AC MAINS socket.

Note on Environmental Protection

Do not throw exhausted batteries in the household refuse.

Hand over the old batteries to your dealer or public collecting points when buying new ones.

Mains supply

• Check if the mains voltage as shown on the type plate (on the back of the set) corresponds

to your local mains voltage. If it does not, consult your dealer or

service organisation.

Connect the mains lead to the AC MAINS socket and the wall socket.

*The mains supply is switched on.

To disconnect the set from the mains completely, withdraw the mains plug from the wall socket.

RADIO OPERATION

Radio aerials

For FM, pull out the telescopic aerial. To improve FM-reception, incline and turn the aerial. Reduce its length if the FM-signal is too strong (very close to a transmitter).

For AM, the set is provided with a built-in aerial, so the telescopic aerial is not needed. Direct the aerial by turning the whole set.

Radio reception

Set the Function switch to RADIO.

Adjust the sound using the VOLUME and DBBS controls.

You may connect stereo headphones having a 3.5mm plug to the jack PHONES.

*Inserting the plug will disconnect the speakers.

Select the wave band using the BAND SELECT selector.

Tune to a desired radio station using the TUNING control.

The set is switched off when the Function switch is in the TAPE position and no buttons are pressed.

4

Page 5
Image 5
Spirit 1776 instruction manual Power Supply, Radio Operation, Battery supply, Mains supply, Radio aerials, Radio reception