Spirit CR800, CU800

CR800_CU800

STEP 4: CONSOLE, SEAT, COVERS, PEDALS

1. Install the front and rear stabilizer covers (32 & 37) and secure to the frame with four M5 x 12mm

screws (99).

2. Install the left and right cup holders (39 & 38) to the rear handlebars with four self tapping screws

(105).

3. Install the bottom seat cushion (61) to the seat carriage (4) with four M6 x 15mm screws (98).

4. Install the Pedals (116 L, 117 R) into the Crank arms (51L, 51R). Remember that the left pedal has

a reverse thread and will be screwed into the crank in the opposite rotation from normal threads.

There is an  stamped into the end of the threaded post of the left pedal and an  in the right.

Make sure to tighten the pedals as much as you possibly can. It may be necessary to re-tighten

the pedals if you feel a thumping during pedaling the bike. A clicking noise, or thumping, sound

during pedaling is usually caused by the pedals being too loose.

5. Connect the two wire harnesses (44 & 45) to the corresponding connectors on the back of the

console. Install the console onto the console mast and secure with four M5 x 12mm sc rews be ing

careful to not pinch the wires.