Spirit CR800, CU800 Using a Heart Rate Transmitter

CR800_CU800

How to wear your wireless chest strap transmitter:

1. Attach the transmitter to the elastic strap using the locking parts.

2. Adjust the strap as tightly as possible as long as the strap is not too tight to remain comfortable.

3. Position the transmitter with the logo centered in the middle of your body facing away from your

chest (some people must position the transmitter slightly left of center). Attach the final end of

the elastic strap by inserting the round end and, using the locking parts, secure the transmitter

and strap around your chest.

4. Position the transmitter immediately below the pectoral muscles.

5. Sweat is the best conductor to measure very minute heart beat electrical signals. However,

plain water can also be used to pre-wet the electrodes (2 black square areas on the reverse

side of the belt and either side of transmitter). Its also recommended that you wear the

transmitter strap a few minutes before your work out. Some users, because of body chemistry,

have a more difficult time in achieving a strong, steady signal at the beginning. After warming

up, this problem lessens. As noted, wearing clothing over the transmitter/strap doesnt affect

performance.

6. Your workout must be within range - distance between transmitter/receiver  to achieve a

strong steady signal. The length of range may vary somewhat but generally stay close enough

to the console to maintain good, strong, reliable readings. Wearing the transmitter immediately

against bare skin assures you of proper operation. If you wish, you may wear the transmitter

over a shirt. To do so, moisten the areas of the shirt that the electrodes will rest upon.

Note: The transmitter is automatically activated when it detects activity from the user’s heart. Additionally, it

automatically deactivates when it does not receive any activity. Although the transmitter is water resistant, moisture

can have the effect of creating false signals, so you should take precautions to completely dry the transmitter after

use to prolong battery life (estimated transmitter battery life is 2500 hours). If your chest strap has a replaceable

battery the replacement battery is Panasonic CR2032.

Caution! Do not use this bike for Heart Rate Control unless a steady, solid Actual Heart

Rate value is being displayed. High, wild, random numbers being displayed indicate a

problem.

Areas to look at for interference, which may cause erratic heart rate:

(1) Microwave ovens, TVs, small appliances, etc.

(2) Fluorescent lights.

(3) Some household security systems.

(4) Perimeter fence for a pet.

(5) Some people have problems with the transmitter picking up a signal from their skin. If you have

problems try wearing the transmitter upside down. Normally the transmitter will be oriented so

the Spirit logo is right side up.

(6) The antenna that picks up your heart rate is very sensitive. If there is an outside noise source,

turning the whole machine 90 degrees may de-tune the interference.

(7) If you continue to experience problems contact your dealer.

Using a Heart Rate Transmitter