Spirit SP-210/310, E-210/310 manual Troubleshooting, Problem Check Cure

12 OPERATING INSTRUCTIONS

3)Turn the cylinder on by turning the cylinder valve counterclockwise.

4)Insert match holder with lit match into the matchlight hole in the front of the cooking box.

MAIN BURNER LIGHTING

WARNING: Do not lean over open barbecue. Keep your face and body at least one foot away from the matchlight hole when lighting the barbecue.

5)Push Front burner control knob down and turn to START/HI.

6)Check that the burner is lit by looking through the matchlight hole on the front of the cooking box. You should see a fl ame

WARNING: If the burner does not light, turn the Front burner control knob to OFF and wait 5 minutes to let the gas clear before you try again or try to light with a match.

7) After the FRONT burner is lit you can turn on the other burner.

Note: Always light the FRONT burner first. The other burner or burners ignite from the FRONT burner.

TO EXTINGUISH

SPIRIT E/SP- 210 & 310

1

4,6

2

7

3

5

Push down and turn each burner control knob clockwise to the OFF position. Turn gas supply off at the source.

*The grill illustrated may have slight differences than the model purchased.

TROUBLESHOOTING

PROBLEM	CHECK	CURE
Burners burn with a yellow or orange flame, in	Inspect Spider / Insect Screens for possible obstructions.	Clean Spider / Insect Screens. (See Section “Annual
conjunction with the smell of gas.	(Blockage of holes.)	Maintenance”)
Symptoms:	The excess fl ow safety device, which is part of the	To reset the excess fl ow safety device turn all burner control
Burners do not light. -or- Burners have a small	barbecue to cylinder connection, may have activated.	knobs and the cylinder valve to OFF. Disconnect the regulator
flickering flame in the HI position. -or-		from the cylinder. Turn burner control knobs to HI. Wait at
Barbecue temperature only reaches 250˚ to 300˚		least 1 minute. Turn burner control knobs to OFF. Reconnect
in the HI position.		the regulator to the cylinder. Turn cylinder valve on slowly.
		Refer to “Lighting Instructions”.
Burner does not light, or flame is low in HI	Is LP fuel low or empty?	Refi ll LP cylinder.
position.
	Is fuel hose bent or kinked?	Straighten fuel hose.
	Does the Left burner light with a match?	If you can light the Left burner with a match, then check the
		Crossover® ignition system.
Experiencing flare-ups:	Are you preheating barbecue in the prescribed manner?	All burners on high for 10 to 15 minutes for preheating.
	Are the cooking grates and Flavorizer® bars heavily	Clean thoroughly. (See Section “Cleaning”)
	coated with burned-on grease?
CAUTION: Do not line the bottom tray
	Is the bottom tray “dirty” and not allowing grease to fl ow	Clean bottom tray
with aluminum foil.	into catch pan?
Burner flame pattern is erratic. Flame is low when	Are burners clean?	Clean burners. (See Section “Maintenance”.)
burner is on HI. Flames do not run the whole
length of the burner tube.
Inside of lid appears to be “peeling.” (Resembles	The lid is stainless steel, not paint. It cannot “peel”. What	Clean thoroughly. (See Section “Cleaning”.)
paint peeling.)	you are seeing is baked on grease that has turned to
	carbon and is fl aking off.
	THIS IS NOT A DEFECT.

If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our web site. Log onto www.weber.com®.

WWW.WEBER.COM®