STEP 2: CONSOLE MAST ASSEMBLY
1.Locate the console mast (12) and console mast cover (49) and slide the cover onto the mast as far as it will go. Make sure the cover is facing the correct way.
2.At the top opening of the main body of the elliptical is a wire harness (39). Unravel and straighten out the wire harness and feed it into the bottom of the console mast tube and out of the top opening.
3.Install the console mast into the receiving bracket in the top of the main body with one hand, while holding the wire harness in the other, keeping tension on the wire so it is not cut by the console mast during installation. NOTE: there is one bolt already installed in the receiving bracket that will engage with the slot at the bottom of the console mast. This needs to be tightened at the end along with the three other console mast bolts.
4.Install the 3/8 split washer (128) onto the 3/8 X
(75)through the left side of the receiving tube into the console mast. NOTE: There is a wire running through the tube. Be careful not to damage or pinch this wire during this procedure. Damage to the electronic console could result. Install and hand tighten the two 3/4 bolts
(76)through the front of the receiving tube into the console mast.
5.Using the two sided, 13mm/14mm wrench, tighten the four bolts firmly. These bolts should be tightened as much as you possibly can. You can now remove the white Styrofoam sheet from just below the bolts. This sheet is there to prevent bolts from falling inside the machine during assembly and should be removed to prevent it from rubbing on moving parts during use of the elliptical. Install the console mast cover (49) by snapping it in place.
6.There will be three electrical wire connectors at the top opening of the console mast. Two
(39). Connect these to the mating connectors on the back of the console. The connectors are keyed to avoid them being plugged in the wrong way. Do not force them. There may be another connector on the back of the console. This connector is used for a different product and will remain unused in the XE700.
7.Storing the excess wire back into the console mast, carefully install the console onto the mounting plate and secure using the four M5 X 12mm Phillips head screws (84). Make sure you do not pinch the wires between the back of the console and the mounting plate. Ensure all excess wire goes down into the tube.
9 | XE Series Elliptical |
|
