Spirit XE700 and two 3.5x12m/m Self Tapping Screws (107).

XE Series Elliptical

STEP 3: HANDLE BAR ASSEMBLY

1. Locate and install the two large wave washers (102) onto the handle bar axle, one on each side.

2. Slide the left and right handle bars onto the appropriate side of the axle. There is a sticker on each

handle bar indicating L for left and R for right. The left and right sides of the elliptical are

determined as if standing on and using the elliptical.

3. Install the two flat washers (131) onto the two 3/8 x 5/8 bolts (76), then install and tighten into the

threaded holes in the ends of the axle.

4. Install the four handlebar covers (157, 157-1, 158, 158-1) with the eight 3.5 x 12 mm screws (107)

5. Install the front (159) and rear (160) console mast covers with three M5 x 15m/m Screws (84)

and two 3.5x12m/m Self Tapping Screws (107).

6. Install the two middle stabilizer covers (116, 117) and the two wheel covers (64) with the six M5 x

12 mm screws (84).

7. Install the four L-brackets (149) on the rear stabilizer with the eight M5 x 12 mm screws (84).