STEP 4: FOOT PAD/CONNECTING ARM ASSEMBLY & REAR SHROUD INSTALLATION.
1.Align the hole of the rod end bearing - located at the end of the Connecting Arms (8&9) - with the holes in the bracket of the Handle Bars (10&11). The rod end bearing should be aligned inside the U shaped Handle Bar bracket. Take two 5/16" x
2.Install the plastic covers
3.Rear shroud (steel cover) installation. Unpack the rear shrouds and remove the 12 screws (84) holding the four front caps (152, 153) to the left and right shrouds (150, 151).
4.Locate and install the two middle mounting brackets (148). These two brackets install from beneath the left and right aluminium rails and are held in place by 5/16 x 3/4 bolts (80). There are holes located in the middle of the aluminium rails where the hole in the brackets line up and the bolts go through.
5.Locate and install the two front mounting brackets (147). These two brackets mount from the top and are secured by 5/16 x 3/4 bolts (80). The two bolts screw into brackets (24) that need to be placed under the aluminium rails.
6.Install the shrouds by lifting the pedal arm and carefully sliding the shroud over the covered wheels of the pedal arms. Lower the pedal arms until the wheels are resting on the aluminium rails again. Position the shroud so the holes in the mounting brackets (147, 148, 149) line up with the mounting holes in the shroud. Install and tighten the twelve M5 x 12mm screws (84) that hold the shrouds in place.
7.
8.Install the center support brace (3) with four 5/16 x 3/4 bolts (80).
13 | XE Series Elliptical |
|
