Spracht cp-2010 Digital Telephone System, Setup of Conference Phone with Digital Phone System

Digital Telephone System

Setup of Conference Phone with Digital Phone System

Note: The DT-102 Digital Telephone System Interface is required for use of the Voice Center Conference Phone with a digital phone system.

Follow the steps below to set up the system. Throughout the instructions, the Voice Center Conference Phone is referred to as “Conference Phone” and the DT-102 Digital Telephone System Interface is referred to as “Digital Interface.”

1. Connect Conference Phone to Digital Interface using the RJ-45 conference phone cable supplied with the Conference Phone.

• Plug one end of the RJ-45 conference phone cable (larger than a standard RJ-11 cable) into the connector labeled “Control Box” on the underside of the Conference Phone.

•Plug the other end of the RJ-45 cable into the Digital Interface connector labeled “Conference Phone.”

2.Connect Digital Interface to digital telephone using RJ-22 telephone handset cables.

•Unplug handset “curly cord” from digital telephone and plug it into the Digital Interface connector labeled “Handset.”

HANDSET	PHONE	CONFERENCE	DC 12V
		PHONE

HANDSET	PHONE	CONFERENCE	DC 12V
		PHONE

•Plug one end of RJ-22 telephone handset cable supplied with the Digital Interface into the Digital Interface connector labeled

“Phone.”

HANDSET	PHONE	CONFERENCE	DC 12V
		PHONE

•Plug the other end of that RJ-22 cable into the handset jack on the digital telephone (from which the handset curly cord was disconnected).

See diagram at top of page 9.

Hang up the handset on the digital telephone.

3.Connect Conference Phone power adapter to Digital Interface. In North America, use 120 VAC power adapter (PA-101, supplied with Conference Phone); in Europe, use 230 VAC power adapter (PA-201, available in EK-101 European adapter kit).

•Plug DC plug on power adapter cord into the Digital Interface connect labeled “DC12V.”

HANDSET	PHONE	CONFERENCE	DC 12V
		PHONE

•Plug power adapter into a nearby electrical outlet (do not exceed voltage rating of power adapter).

Note: At this point, the Conference Phone will emit a musical jingle; this self-test allows it to automatically calibrate its performance for the acoustic environment.

Note: See system illustration on next page.

8