LRTZ2600
6. Set up
MOUNTING ENGINE
1.Push the drive shaft housing toward the clutch hous- ing and move it by hand to check that the drive shaft is engaged with the gears.
2.Insert the drive shaft housing into the clutch housing until it bottoms, and align the positioning holes on the clutch housing and the shaft tube and install the screw. When difficult to engage, twist the engine slightly.
3.Fasten the clamp securely with two screws.
Bolt
WARNING
Never use any screws other than those specified by the manufacturer, or the engine can get loose, result- ing in a hazardous event.
IMPORTANT
Tighten the screws gradually by turns.
CONNECTING THROTTLE WIRE
1.Remove the air cleaner cover.
2.Connect the end of the throttle wire to the joint on the top of the carburetor.
CONNECTING SWITCH WIRES
•Connect the switch wires between the engine and the main unit. Pair the wires of the same color.
INSTALLING HANDLE
•Mount the handle to the shaft tube and clamp it at a location that is comfortable to you.
About 48cm
ATTACHING THE TRIMMING MECHANISM
1.Remove the cap on the end of the main pipe.
2.Remove the screw screwed into the end of the trim- ming mechanism.
3.Insert the end of the trimming mechanism into the main pipe.
4.Line up the hole on the end of the trimming mecha- nism into which the screw is to be inserted with the hole on the main pipe, and screw the screw firmly in.
5.Using a
(1)Main pipe
(2)Trimming mechanism
(3)Screw hole
(4)Screw
(5)Fastening bolt
BALANCE UNIT
1.Put on strap and attach unit to strap.
2.Depending on the working posture, slide clamp up or down until unit balances and the strap fits your body.
