Zenoah LRTZ2600 Adjusting The Maximum Speed, Adjusting The Angle Of The Cutting Blades, Operation

8. Operation

ADJUSTING THE MAXIMUM SPEED

•The screw at the throttle lever is for adjusting the maxi- mum rpm.

•Turning the screw crock-wise, the rpm becomes down, the otherwise, the rpm becomes up. (STANDARD OP- ERATION SPEED: 8000 to 9500 rpm)

Running engine with faster engine speed than 9500 rpm may damage the engine, slower engine speed than 8000 rpm may cause of the poor cutting ability.

up	adjust screw
	down

WARNING

•This product is equipped with extremely sharp blades, and when used improperly these blades can be ex- tremely dangerous, and improper handling can cause accidents which may in turn lead to serious injury or death. For this reason, you should always be careful to follow the following instructions when using your trimmer.

•Never hold the trimmer in a way in which the blades are pointed towards someone else.

•Never allow the blades to come into proximity with your body while the engine of the trimmer is in opera- tion.

•Always be sure to turn off the engine before chang- ing the angle of the blades, removing branches which have become stuck in the blades, or at any other time when coming into close proximity with the blades.

•Always wear work gloves made of leather or some other sturdy material when using the trimmer.

•Always place the blade cover provided with the trim- mer over the blades when not in use.

•Falling branches may fall onto the face or into the eyes, resulting in injuries, scratches, and cuts, and for this reason you should always be sure to wear a helmet and face protector when using your trimmer.

NOTE

•The thickness of branches which may be cut using this trimmer is limited to up to approximately 4.8mm. Never try to cut branches thicker than this, as doing so may result in damage to the trimmer.

LRTZ2600

ADJUSTING THE ANGLE OF THE

CUTTING BLADES

1.	Stop the trimmer engine.
2.	Turn the bolt located on the top of the trimming mecha-
	nism counter-clockwise to loosen it.		G
3.	Adjust the angle of the blades to the desired angle,		B
	and then fix the bolt firmly back into place.
	(1)	Clamp bolt
	(2)	Trimming mechanism
	(3)	Tighten
	(4)	Loosen

GB-11