LRTZ2600
8. Operation
STARTING ENGINE
WARNING
The cutting head will start moving upon the engine starts.
1.Rest the unit on a flat, firm place. Keep the cutting head off the ground and clear of surrounding objects as it will start moving upon starting of the engine.
2.Push the primer pump several times until overflown fuel flows out in the clear tube.
3.Move the choke lever to the closed position. choke lever
close
open
4.Set the ignition switch to the “RUN” position. While pulling the throttle lever(1,2), push the throttle set but- ton(3), and release the throttle(2), then the throttle le- ver is in to the “start position”.
(A) Run
(B) Stop
(C) Ignition switch
5.While holding the unit firmly, pull out the starter rope quickly until engine fires.
IMPORTANT
Avoid pulling the rope to its end or returning it by releas- ing the knob. Such actions can cause starter failures.
6.Move the choke lever downward to open the choke. And restart the engine.
7.Allow the engine to warm up for a several minutes before starting operation.
NOTE
1.When restarting the engine immediately after stop- ping it, leave the choke open.
2.Overchoking can make the engine hard to start due to excess fuel. When the engine failed to start after several attempts, open the choke and repeat pulling the rope, or remove the spark plug and dry it.
STOPPING ENGINE
1.Release the throttle lever and run the engine for a half minute.
2.Shift the ignition switch to the “Stop” position.
IMPORTANT
Except for an emergency, avoid stopping the engine while pulling the throttle lever.
ADJUSTING THROTTLE CABLE
The normal play is 1 or 2mm when measured at the car- buretor side end. Readjust with the cable adjuster as required.
04in (1 to 2mm)
Cable adjuster
ADJUSTING IDLING SPEED
1.When the engine tends stop frequently at idling mode, turn the adjusting screw clockwise.
2.When the cutting head keeps moving after releasing the trigger, turn the adjusting screw
Idle adjusting screw
NOTE
Warm up the engine before adjusting the idling speed.
