English - 26
continued...
Basic Functions

6. Program Information

EPG-Electronic Program Guide
The electronic program guide gives you a programme list for the channels.
➢1. This service depends on service provider.
2. After receiver recognized the GMT- time from the signal which takes
few seconds, it can display correct EPG information.
•Press the GUIDEbutton while you are viewing a program.
This function is displayed on the screen by using only time.
•REDbutton: Red button is for moving back to the previous date.
•GREENbutton: Green button is for moving to the next coming date.
•INFObutton: This button is used to watch the program information, if there
is more information than one page. Use the …or †buttons to move up
and down pages.
•œor √button: Use to display the program list by 30 minutes per block.
Time interval can be adjusted by pressing buttons as followings on EPG
screen:
1 button: 1 hour and 30 minutes
2 button: 30 minutes
3 button: 15 minutes
•Select the channel by pressing the …or †buttons and press the
ENTER/OK () button to watch this channel.
Operating the DTV Menu

Main Menu

After installing your antenna system and TV with appropriate connectors.
• Plug in the AC main power and switch on the TV.
• Press the D.MENUbutton to bring up the main menu.
The following on-screen display will appear:
The sub menu topics will be displayed. For the sub-menus Installation,
Channel Organisingand Parental Lock, you need the PIN Code.

1. Installation

This menu consists of 4 sub-menus:
Select Country, Auto Scanning, Manual Scanning and Reset to Factory
Defaults.
•Select Installationby pressing the ENTER/OK () button in the
main menu mode to select the sub menu.
•Enter the PIN Code.
➢If you have not entered your own PIN Code then the PIN Code 0000
applies, which was set at the factory.
➢Once you have entered PIN Code, you do not have to input the code
again unless you turn the TV power off.
Installation
Channel Organising
Parental Lock
System Setup
Installation >
Installation
Channel Organising
Parental Lock
System Setup
Select Country
Auto Scanning
Manual Scanning
Reset to Factory Defaults
Installation >Select Country