English - 34
Instructions on Securing the SET to the Wall Mount Bracket
➢The exterior of the SETmay be different than the picture. (Assembly and installation of the plastic hanger is
the same.)
1Remove the screws from the back of the PDP. 2Use the screw and assemble the plastic hanger.
(Please refer to the following picture.)
☛1Please ask the installers to install the wall
mount bracket.
2Please be sure to check if the plastic hanger is
completely secured on both the left and right
side after hanging the SETon the wall mount
bracket.
3Please avoid catching your fingers while
installing and adjusting the angle.
4Please tightly secure the wall mount bracket to
the wall to avoid injury from a falling SET.
How to Install the Wall Mount Bracket
3Tighten the screws of the plastic hanger (shown
in picture 2) to the back side of the PDP. 4Remove the Safety Pins. Fasten the 4 plastic
latches assembled at step
(#)
on the back side of
the PDPusing the guide holes of the wall mount,
push
(!)
and hook
(@)
down to secure the PDPon
the wall mount as illustrated. Secure the PDPby
inserting the Safety Pins.
continued...
PDPpanel
Wall attachment
panel bracket Wall
BN68-00889W-01Eng(Spa) 9/20/06 3:15 PM Page 34