MAINTENANCE PROCEDURES | 9 |
|
REMOVE FRONT PANEL
1Disconnect the appliance from the power source.
2Remove the four 5/16 headed screws located at the bottom of the front panel.
3After the screws have been removed, grasp the panel on both sides and pull forward.
Allow the panel to drop free of the top assembly and set aside.
INSTALL FRONT PANEL
1Locate left and right side of front panel over guide pins on cabinet.
2While applying upward pressure, use a 5/16 nut driver and screw the four 5/16 headed screws back in the bottom of the front panel.
HOW TO RAISE TOP ASSEMBLY
1Remove front panel.
2Remove the two
3Lift up on the front of the top until the two front clips have cleared the edge of the cabinet. Note: Secure the lid to the top panel with a piece of tape or some other means. Once the top is raised vertically, the lid might open and fall backwards. This could damage the lid or cause it to become detached from the top.
4Pull the plastic top assembly towards you an inch to free up the hinges on the back. Then lift the top until you can gain access to the rear wall of the cabinet. Note: Again, secure the top so it will remain open while you are working in this area. If the top is not secured, it could fall closed while you are working in this area.
ACCESSING THE MOTOR CONTROL BOARD
1First unplug the machine from its power source.
2Remove front panel
3Raise top assembly
4The motor control board is now accessible. The location of the board is on the rear upper right corner of the cabinet.
