ASSEMBLY INSTRUCTIONS
STEP 8
NOTE: The RIGHT PEDAL(35) has R stamped on the end of the pedal shaft. The RIGHT PEDAL(35) has right hand threads and is tightened by turning clockwise. The LEFT PEDAL(34) has L stamped on the end of the pedal shaft. The LEFT PEDAL(34) has left hand threads and is tightened by turning counter clockwise.
Thread the RIGHT PEDAL(35) to the right side of the CRANK(9) as shown. Tighten the pedal securely. Do the same to attach the LEFT PEDAL(34) to the left side of the CRANK(9).
STEP 9
Install two AA batteries into the METER(27), two batteries included. See page 13 for detailed battery installation instructions. Plug the SENSOR WIRE(28) into the METER(27), and push the excess wires back into the METER POST(26). Place the METER(27) onto the plate on the METER POST(26) and secure with ROUND
HEAD SCREWS(M5x0.8x15mm)(54).
NOTE: Be careful not to damage the wires when attaching the METER(27).
10
