ASSEMBLY INSTRUCTIONS
Place all parts from the box in a cleared area and position them on the floor in front of you. Remove all packing materials from your area and place them back into the box. Do not dispose of the packing materials until assembly is completed. Read each step carefully before beginning. If you are missing a part please call our
R |
L |
The bracket |
needs to |
point |
toward |
the footrest. |
The bracket needs to |
point toward the footrest. |
STEP 1
Unfold the BASE ASSEMBLY to an upright position by moving the FRONT FRAME(1) away from REAR FRAME(2). Then push down on the middle of the two FOLDING LINKAGES(3) until they are fully locked down.
STEP 2
There is a "L" decal on the LEFT PIVOT ARM(5), and a "R" decal on the RIGHT PIVOT ARM(6). Slide the bottom of the LEFT and RIGHT PIVOT ARMS(5, 6) into the brackets located at each side of the MAIN FRAME(4). Align the hole on the arm with the peg on the bracket, and insert the peg into the hole to lock the PIVOT ARMS(5, 6) in position. Then secure the PIVOT ARMS(5, 6) on the pegs with ROUND HEAD BOLTS(M6x1x10mm)(54) and LARGE WASHERS(M6)(53).
STEP 3
Attach the MAIN FRAME(4) onto the REAR FRAME(2) by sliding the slots in the ends of the PIVOT ARMS (5, 6) into the slots on the REAR FRAME(2). Secure the PIVOT ARMS(5, 6) in the slots by screwing the HEX BOLTS(M8x1.25x15mm)(45), WASHERS(M8)(51), LARGE WASHERS(M8)(52), and NYLOCK NUTS(M8x1.25)(49) onto the brackets on the REAR FRAME(2).
7
