Stamina Products 55-2010 owner manual Hardware Identification Chart

HARDWARE IDENTIFICATION CHART

This chart is provided to help identify the hardware used in the assembly process.

After unpacking the unit, open the hardware bag and make sure that you have the following items:

	3/16"		1/4"	5/16"		3/8"		1/2"
											INCHES
0	1/2		1	1/2	2	1/2	3		1/2	4	1/2		5	1/2	6
															in.
0	10	20	30	40	50	60	70	80	90	100	110	120	130	140	mm.
															150
									MILLIMETERS					length
	6		8		10		12

Place washers, the end of bolts or screws on the circles to check for the correct size. Use the small scale to check the sizes of bolts and screws.

length

NOTICE: The length of all kinds of screws and bolts are not included themselves head, except the flat head screws and bolts.

Part No. and Description		Qty
80	Carriage Bolt (M8 x 1.25 x 70mm)	4
81	Bolt, Socket Head (M6 x 1 x 35mm)	4
83	Bolt, Button Head (M8 x 1.25 x 90mm)	2
91	Bolt, Button Head (M10 x 1.5 x 85mm)	2
86	Bolt, Hex Head (M8 x 1.25 x 50mm)	2
87	Bolt, Hex Head (M8 x 1.25 x 20mm)	1
90	Bolt, Round Head (M8 x 1.25 x 20mm)	4
92	Screw, Round Head (M5 x 0.8 x 30mm)	1
70	Nylock Nut (M10 x 1.5)	2
72	Nylock Nut (M6 x 1)	4
73	Nylock Nut (M8 x 1.25 x 8mm thick)	8
69	Lock Washer (M8)	1
68	Washer (M10)	2
93	Washer (M5)	1

NOTE: 1. Some of the hardware items listed may be attached to other parts.

2. Bolt length is measured from the bottom of the bolt head to the end of the bolt.

5