HP HSC/I 1000Base-SX, I 1000Base-T manual Diagnostic Flowcharts, Chart Type of Test Purpose

Troubleshooting

Diagnostic Flowcharts

Diagnostic Flowcharts

The following table summarizes the types of network tests in the diagnostic flowcharts.

Table 4-1

Chart	Type of Test	Purpose
1	Cable and LED	Checks that hardware, cables, and connectors between your
	Test	system and card are operational.
2	Link Level Test	Checks communication between link levels on source and
		target host using linkloop(1M).
3	Network Level	Validates arp(1M) entries and remote host availability.
	Tests	Checks communication between network layers on source
		and target host using ping(1M).
3a	ARP Test	Verifies that an entry exists for the remote host in your
		system's ARP cache.
3b	ping Test	Checks communication between network layers on the source
		and target host.
4	Transport Level	Checks communication between transport layers on source
	Test	and target host using telnet and ftp sessions.
5	Bridge/Gateway	Checks general network connections through a gateway.
	Loopback Test
6	Configuration	Verifies configuration of network interface on a host using
	Tests	ioscan(1M), lanscan(1M), netfmt(1M), lanadmin(1M), and
		ifconfig(1M).
6a	ioscan and lanscan	Verifies configuration of network interface on a host.
	Test
6b	netfmt and	Verifies configuration of network interface on a host.
	lanadmin Test
6c	ifconfig Test	Verifies configuration of network interface on a host.

Chapter 4 29