HP HSC/I 1000Base-SX, I 1000Base-T Flowchart 6c Procedures

Troubleshooting

Diagnostic Flowcharts

Flowchart 6c Procedures

•Execute ifconfig(1M) on the interface you want to conﬁgure to ensure that interface is enabled. Example:

ifconfig lan1 192.6.1.17 netmask 255.255.255.0 up

Next, execute ifconfig interface to test and verify ﬂag setting is UP and correct IP address is displayed. Example:

ifconfig lan1

<UP,BROADCAST,RUNNING,MULTICAST,CKO>

•If IP and ﬂags are correct, verify there is an entry for card interface in /etc/rc.config.d/netconf. If so, go to Network Level Tests. Otherwise, add correct interface parameters to /etc/rc.config.d/netconf file and reboot. If ﬂags are incorrect, correct them with ifconfig and repeat ifconﬁg Test. Otherwise, if ifconfig is not successful and error messages appear, correct them accordingly and repeat ifconﬁg Test.

•If you cannot correct errors, call your HP representative.

Chapter 4