HP I 1000Base-T, HSC/I 1000Base-SX manual RFC 1213 MIB, Field Description

Gigabit Ethernet lanadmin Display

RFC 1213 MIB II

RFC 1213 MIB II

Following are descriptions of the statistics fields in the lanadmin(1M) command display. For more detailed information about the fields, refer to RFC 1213.

Field	Description
Network Management ID	A unique ID assigned by the system for the network
	management of each network interface.
PPA Number	A unique number assigned to each network interface,
	distinct from NMID.
Description	A textual string containing information about the
	interface.
Type (value)	The type of interface, distinguished according to the
	physical/link protocols, immediately below the
	network layer in the protocol stack.
	Gigabit Ethernet can have one of the following
	values: ethernet or IEEE 802.3.
MTU Size	The size of the largest datagram which can be
	sent/received on the interface specified in octets. This
	value can be 1500 or 9000.
Speed in bits per second	The speed of the card — 1000 Mbps for 1000Base-SX
	and 10, 100, or 1000 Mbps for 1000Base-T.
Station Address	The interface address at the protocol layer
	immediately below the network layer in the protocol
	stack. For interfaces which do not have such an
	address, such as serial line, this object contains an
	octet string of zero length.
Administration Status	The status of the card. This parameter is set to up(1)
	and is not configurable. It will have one of the
	following values:
	up(1)	Ready to pass packets
	down(2)	Not operative
	testing(3)	In test mode
Operation Status	The status of the link. This value is the same as the
	administration status. If the value is up, the link is
	operational.
Last Change	The value of SysUpTime at the time the interface
	entered its current operational state. If the current
	state was entered prior to the last reinitialization of
	the local network management subsystem, then this
	object contains a zero value.

56 Appendix A