Stamina Products 55-4700A Operational Instructions Headpad Adjustment and USE, Storage

OPERATIONAL INSTRUCTIONS

HEADPAD ADJUSTMENT AND USE

The HEADPAD(60) is designed to support the natural curve of your neck. It can be used to provide comfort, support and postural alignment for reformer exercises that are performed while lying on your back. Do not use the HEADPAD(60) for exercises that require you to lift your hips higher than your head.

With the HEADREST(14) in the flat position, place the HEADPAD(60) on top of the HEADREST(14) with the thickest part of the HEADPAD(60) under your neck. Make sure that the elastic strap on the HEADPAD(60) is around the HEADREST(14).

STORAGE

Make sure that both FOAM PADS(16) are in the carriage when using the HEADPAD(60) attached to the HEADREST(14).

1.Store the AeroPilates Premier Studio in a clean, dry place.

2.It is recommended that two people be available to move the AeroPilates Premier Studio.

3.To move the AeroPilates Premier Studio: First, attach one of the TENSION CORDS(10) in the slot on the FRONT FRAME(1) to prevent the CARRIAGE(7) from moving. Second, grasp the FRONT and REAR FRAME(1, 2) to remove the AeroPilates Premier Studio from its stand. Third, lift up the AeroPilates Premier Studio from the REAR FRAME(2) to move the AeroPilates Premier Studio with the transport wheels on the FRONT FRAME(1). Fourth, grasp both ends of the stand to move it.

MAINTENANCE

The safety and integrity designed into the AeroPilates Premier Studio can only be maintained when the AeroPilates Premier Studio is regularly examined for damage and wear. Special attention should be given to the following:

1.It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.

2.Worn or damaged components should be replaced immediately or the AeroPilates Premier Studio removed from service until repair is made.

3.Verify that the CAUTION LABEL(68) is present and legible. Replace the CAUTION LABEL(68) if it is missing or damaged.

4.Verify that the ROPES(18) are properly installed on the PULLEY SETS(22).

5.Check the condition of the ROPES(18) and replace if they are frayed or worn.

6.Check the PLASTIC SNAP HOOKS(19) on the ends of the ROPES(18). Replace the ROPES(18) if

PLASTIC SNAP HOOKS(19) are damaged or deformed.

7.Check the TENSION CORDS(10). If a TENSION CORD(10) is stretched and loose, re-tie the knot on the end of the cord. Replace TENSION CORDS(10) that are frayed or worn.

8.Check the BUNGEE CORD(52) on the CARDIO REBOUNDER(50) for wear. Replace the CARDIO REBOUNDER(50) if the BUNGEE CORD(52) is frayed or worn.

9.Check the PULLEY SETS(22) for excessive wear. Replace worn PULLEY SETS(22).

10.Check the HAND STRAPS(20) and replace if damaged or worn.

11.Check the FOAM SLEEVE(6) and FOAM PADS(16) and replace if damaged or worn.

12.Check the STOP PLATES(30, 31) for looseness or damage and replace if damaged or worn.

13.Check the CUSHION(13) and replace if it is damaged or worn.

14.Check and clean the ROLLERS(8) and the rolling surfaces on the rails. Clean by wiping with a dry cloth.

15.Only Stamina Products supplied components shall be used to maintain/repair the AeroPilates

Premier Studio.

16.Keep your AeroPilates Premier Studio clean by wiping with an absorbent cloth after use.

12