HARDWARE IDENTIFICATION CHART
This chart is provided to help identify the hardware used in the assembly process. Place the washers or the ends of the bolts or screws on the circles to check for the correct diameter. Use the small scale to check the length of the bolts and screws.
| 3/16" | 1/4" | 5/16" |
| 3/8" |
| 1/2" |
|
|
|
|
|
|
|
|
|
|
|
|
|
| INCHES |
|
|
|
0 | 1/2 | 1 | 1/2 | 2 | 1/2 | 3 | 1/2 | 4 | 1/2 | 5 | 1/2 | 6 in. |
mm.
010 20 30 40 50 60 70 80 90 100 110 120 130 140 150
|
|
| MILLIMETERS | length |
6 | 8 | 10 | 12 |
|
NOTICE: The length of all bolts and screws, except those with flat heads, is measured from below the head to the end of the bolt or screw. Flat head bolts and screws are measured from the top of the head to the end of the bolt or screw.
length 
After unpacking the unit, open the hardware bag and make sure that you have all the following items. Some hardware may be already attached to the part.
Part No. and Description | Qty | |
38 | Screw, Round Head (M5 x 0.8 x 25mm) | 4 |
42 | Nylock Nut (M8 x 1.25) | 2 |
47 | Washer (M8) | 6 |
26 | Locking Knob | 4 |
27 | Plastic Wheel | 2 |
28 | Rubber Foot | 4 |
| 6 |
|
