HARDWARE IDENTIFICATION CHART

This chart is provided to help identify the hardware used in the assembly process. Place the washers or the ends of the bolts or screws on the circles to check for the correct diameter. Use the small scale to check the length of the bolts and screws.

 

3/16"

 

1/4"

5/16"

3/8"

 

1/2"

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

INCHES

 

 

 

0

1/2

 

1

1/2

2

1/2

3

 

1/2

4

1/2

5

1/2

6 in.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

mm.

0

10

20

30

40

50

60

70

80

90

100

110

120

130

140

150

 

 

 

 

 

 

 

 

 

MILLIMETERS

 

length

 

6

 

8

 

10

 

12

 

 

 

 

 

 

 

 

NOTICE: The length of all bolts and screws, except those with flat heads, is measured from below the head to the end of the bolt or screw. Flat head bolts and screws are measured from the top of the head to the end of the bolt or screw.

length

After unpacking the unit, open the hardware bag and make sure that you have all the following items. Some hardware may be already attached to the part.

Part Number and Description

Qty

37

Bolt, Button Head (M8 x 1.25 x 40mm)

4

40

Screw, Round Head (M5 x 0.8 x 30mm)

1

41

Screw, Round Head (M5 x 0.8 x 10mm)

2

42

Bolt, Round Head (M6 x 1 x 15mm)

1

51

Arc Washer (M8)

4

53

Nylock Nut (M8 x 1.25)

2

6

Page 6
Image 6
Stamina Products A450-255 owner manual Hardware Identification Chart, Part Number and Description, 100 110 120 130 140 150