ASSEMBLY INSTRUCTIONS
STEP 9
NOTE: The RIGHT PEDAL(38) has R stamped on the end of the pedal shaft. The RIGHT PEDAL(38) has right hand threads and is tightened by turning clockwise. The LEFT PEDAL(36) has L stamped on the end of the pedal shaft. The LEFT PEDAL(36) has left hand threads and is tightened by turning counterclockwise.
Thread the RIGHT PEDAL(38) into the RIGHT CRANK(33) as shown. Tighten the pedal securely. Select the RIGHT PEDAL STRAP(39) which has R marked on the bottom side of the strap. Snap the two hole end to the inside edge of the RIGHT PEDAL(38). Snap the other end to the outside edge of the RIGHT PEDAL(38) with the R mark on the bottom of the RIGHT PEDAL STRAP(39). Select adjustment holes which allow your foot to be easily removed from the pedals.
Use the same procedure to attach the LEFT PEDAL(36) to the LEFT CRANK(32) and snap the LEFT PEDAL STRAP(37) to the LEFT PEDAL(36).
STEP 10
Slide the UPRIGHT SLEEVE(29) over the UPRIGHT(3). Connect the CONNECTION WIRE(25) to the CONTROL WIRE(24). Insert the UPRIGHT(3) onto the FRONT FRAME(1) and secure with FLAT HEAD BOLTS(M8x1.25x15mm)(70). Slide the UPRIGHT SLEEVE(29) down to cover the bolt heads.
11
