ADJUSTMENT INSTRUCTIONS
STEP 6: Hold the FAN(18) so that the FRONT SPROCKET is on your left side as shown.
STEP 7: Loosen NUTS "A" and "B" until at least 1/2" of FAN AXLE is showing between NUT "A" and
the FAN BUSHING.
STEP 8: Tighten NUT "C" completely until it bottoms out on the last FAN AXLE thread.
STEP 9: Tighten NUT "A" completely against FAN BUSHING, then back off 1/4 turn or until the FAN AXLE has a very small amount of play side to side.
STEP 10: Hold NUT "A" and tighten NUT "B" completely against the SPEED PICKUP and NUT "A". NOTE: The FAN should be able to spin freely on the FAN AXLE after completion of this step.
FAN | NUT A |
FAN BUSHING | SPEED PICKUP |
| |
WASHER | NUT B |
FAN AXLE
WASHER
NUT C
WAVY WASHER | FAN BUSHING | |
| ||
FRONT | RESISTANCE HUB | |
SPROCKET | ||
|
STEP 11: Reverse STEPS 1 through 4 to reinstall the FAN(18), FAN CAGES(28), CHAIN(17), and CHAIN GUARDS (29, 30).
NOTE: DO NOT tighten
STEP 12: The CHAIN must be adjusted as follows:
a. Make sure the CHAIN(17) is on both the FRONT and REAR SPROCKETS.
TAB
b.Tighten NUT(M6x1)(65) on EYE BOLTS(22) until all slack is removed from CHAIN(17) and CENTER of NUTS(3/8")(66) are the same distance from TAB on both sides of BIKE.
c.Tighten NUTS(3/8")(66).
16
