Standard Horizon CP180 owner manual Adjusting the Time, Adjusting Time

3.2ADJUSTING THE TIME

The time information supplied by the GPS satellites is in Universal Time Coordinates (UTC or Greenwich England Mean Time). To change the GPS Chart Plotter to read the correct time, first you must figure out the offset and if it is daylight savings time. For example on the West coast of theUnitedStatesorPacificStandardTimetheoffsetneededwouldbe–08:00or–07:00fordaylight savings time, Eastern Standard Time –05:00 or –04:00 for daylight savings time.

Figure 3.2 - Adjusting Time

NOTE

This map shows offset for standard time. For daylight saving time, subtract one hour from the offset time.

Figure 3.2a - Time Setup menu

1.Press [MENU]. Move the ShuttlePoint knob to highlight SETUP MENU and press [ENT].

2.Move the ShuttlePoint knob to highlight GENERAL SETUP and press [ENT] or move the ShuttlePoint knob to the right.

3.Move the ShuttlePoint knob to highlight TIME SETUP and press [ENT] or move the ShuttlePoint knob to the right.

4.Move the ShuttlePoint knob to highlight GPS TIME OFFSET and press [ENT] or move the ShuttlePoint knob to the right.

5.Move the ShuttlePoint knob down to select +00:00, press [ENT] and move the ShuttlePoint knob to the right to edit the number.

6.Look at the table and find the offset for your area. You will need to enter this offset to

Page 32 GPS Chart Plotters