Installation
Face Plate Installation
1.To install a face plate:
a)Attach the face plate to the front panel of the instrument.
b)Twist the face plate clockwise until tight.
2.To remove face plate, twist it anticlockwise until loose and detach.
Instrument Installation
The instrument can be easily installed in different types of instrument panels. Refer to Figures 3, 4, and 5 for the following steps.
1.Select a suitable location for the instrument. When selecting the location for mounting, the following are recommended:
•Controls of the instrument must be accessible to the user.
•Electrical connections must be routed to the boat system as directly as possible, minimising the length of cable where practical.
•Location should provide as much protection from the elements as possible.
•The panel for mounting the instrument should be 1/8 to 3/4 inch thick.
•The space behind the instrument panel must have a depth of at least 3.75 inches. See Figure 1 for dimensions of the instrument.
2.Drill a
3.With the mounting bracket removed, insert the instrument into the hole until the back of the face plate is flush with the outside mounting wall.
4.Slide the bracket over the body of the instrument.
Note:
Orient the bracket in such a manner that it does not cover the buzzer.
5.Tighten the mounting nut until the bracket is secure.
2.5"2.5"
2.5"
| INTERCHANGEABLE FACE PLATES | ||||
ROUND FACE PLATE |
| SQUARE FACE PLATE | |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| .75" |
|
|
|
| .5" |
| 3.75" |
|
|
| ||||||
|
|
|
|
|
Figure 1. Depth Sounder Dimensions
DS41 Owner’s Manual9
