SAFETY PRECAUTIONS
Tool operators and maintenance personnel must always comply with the safety precautions given in this manual and on the stickers and tags attached to the tool and hose.
These safety precautions are given for your safety. Re- view them carefully before operating the tool and before performing general maintenance or repairs.
Supervising personnel should develop additional pre- cautions relating to the specific work area and local safety regulations. If so, place the added precautions in the space provided in this manual.
The CR27 Hydraulic Circular Saw will provide safe and dependable service if operated in accordance with the instructions given in this manual. Read and understand this manual and any stickers and tags attached to the tool and hoses before operation. Failure to do so could result in personal injury or equipment damage.
•Operator must start in a work area without bystand- ers. The operator must be familiar with all prohibited work areas such as excessive slopes and danger- ous terrain conditions.
•Establish a training program for all operators to en- sure safe operation.
•Do not operate the tool unless thoroughly trained or under the supervision of an instructor.
•Always wear safety equipment such as goggles, ear, head protection, and safety shoes at all times when operating the tool.
•Do not overreach. Maintain proper footing and bal- ance at all times.
•Do not inspect or clean the tool while the hydraulic power source is connected. Accidental engagement of the tool can cause serious injury.
•Supply hoses must have a minimum working pres- sure rating of 2500 psi/175 bar.
•Be sure all hose connections are tight.
•The hydraulic circuit control valve must be in the OFF position when coupling or uncoupling the tool.
Wipe all couplers clean before connecting. Use only
•Do not operate a damaged, improperly adjusted, or incompletely assembled tool.
•Do not operate the tool at oil temperatures above 140 °F/60 °C. Operation at higher oil temperatures can cause operator discomfort and may damage the tool.
•To avoid personal injury or equipment damage, all tool repair, maintenance and service must only be performed by authorized and properly trained per- sonnel.
•Do not exceed the rated limits of the tool or use the tool for applications beyond its design capacity.
•Always keep critical tool markings, such as labels and warning stickers legible.
•Always replace parts with replacement parts recom- mended by Stanley Hydraulic Tools.
•Check fastener tightness often and before each use daily.
•Do not wear loose fitting clothing when operating the tool.
•Keep all parts of your body away from the rotating saw blade.
•Keep the saw blade off all surfaces when starting the circle saw.
•Do not reverse saw blade rotation direction by changing fluid flow direction.
•Without the use of
•Never cock, jam or wedge the saw blade during op- eration.
•Eye injury and cutting or severing of body parts is possible if proper procedures are not followed.
CIRCULAR SAW SPECIFIC SAFETY PRECAUTIONS
•Do not rely exclusively upon the safety devices built into the saw. As a circle saw user, several steps must be taken to keep your cutting jobs free from accident or injury.
•Ensure the saw blade is correctly mounted and tightened before each use.
•Keep a good firm grip on the pole saw with both hands. Place your right hand on the rear handle and your left hand on the outer tube assembly when op- erating. Use a firm grip with your thumbs and fingers encircling the saw handle and outer tube assembly.
A firm grip helps keep control of the saw. Do not let go.
CR27 User Manual ◄ 5
