Routine Maintenance, Loading And Unloading | Stanley Black & Decker MHP3

OPERATION

TO TURN LEFT

FROM A STOP Move the right control forward and the left control backward

•TO TURN RIGHT FROM A STOP: Moving the left track control forward and moving the right track control backward at the same time will increase the turning rate.

TO TURN RIGHT

FROM A STOP Move the left control forward and the right control backward

LOADING AND UNLOADING

1.Use loading ramps or a loading dock to load and un- load the machine. Ensure loading ramps are strong enough to support the load. When using ramps, do not exceed a 15 degree incline (27 percent).

2.Ensure the wheels of the trailer and the tow vehicle have been chocked front and rear.

3.Use the “SLOW” throttle setting when loading or unloading. Always switch the two-speed control to

“LOW” speed operation when moving in reverse.

Loading and unloading of any type of machine is dangerous. Never attempt to load or unload the machine without loading ramps or a loading dock. Loading ramps must be strong enough, have a low angle, and correct height. Load and unload the machine on a level surface. Never attempt to load or unload the machine if the ramp incline exceeds 15 degrees. Failure to follow these instructions may result in serious injury or death.

4.Drive the machine onto the trailer backwards (en- gine first). This will help prevent instability and keeps the operator “up hill” from the machine during load- ing and unloading.

5.After loading, place chocks at the front and rear of the tracks.

LIFTING

The unloaded TracHorse can be lifted using the single central lift point. Some safety rules may require 3-point lifting. (Center lift point plus 2-points on forward side of rails.)

If lifting with any items in the bed, a 3-point lift is re- quired. (A 3-point lifting sling is available, refer to Acces- sories page.)

TRANSPORTING

1.Read the instructions for loading and unloading in this section.

2.Use chains and binders to secure the load to the trailer.