Push tractor unit
Installing the push tractor unit
The push tractor unit allows you to print on continuous fanfold paper up to 10" wide. The push tractor unit consists of two end pieces joined by two silver metal rods. The metal rods have two black sliding tractor units and a black sliding support piece mounted on them.
Install the push tractor unit using the following steps:
•Make sure the printer is switched off.
•Open the front cover by hooking your fingers under the two small projecting tabs on either side of the front cover. Grip the cover firmly and pull upwards. The front cover will come loose.
•Now pull the cover up and forwards so that it swings open.
•Open the rear cover by pushing it backwards so that it folds back and down.
•Pull the release lever forward.
•Hold the push tractor unit with your thumb and forefinger on the ridges near the top and with the slot facing towards you.
Ridges
English
Slots
End pieces
Tractors
Ridges
Page 3
