– 50 –
< Settings for Communication Speed >
To change the serial communication settings, change the following DIP switch settings.
(Ex-factoryDefaultSettings:DSW1to6areON,7and8areOFF.)
Switches ON OFF
 DSW1-1 BaudRateSetting(Seetablebelow)
DSW 1-2
DSW 1-3 Fixed at On
DSW 1-4 Parity Disabled Parity Enabled
DSW 1-5 Odd Parity Even Parity
DSW 1-6 Fixed at On
DSW 1-7 Fixed at Off
DSW 1-8 Fixed at Off
 BaudRatesBPS 4800BPS 9600BPS 19200BPS 38400BPS
DSW 1-1 OFF ON ON OFF
DSW 1-2 ON ON OFF OFF
* If incorrect switch settings are made, there may be a failure of the card reader/writer.
Be careful when making setting changes.
Appendix A: Connection Settings

A-1. RS-232C Interface

<RS-232CSerialInterfaceSpecications>
1 Connectors D-Sub9PIN (Male)*Reader/WriterSide
2 CompatibleConnectors D-Sub9PIN (Female)*CableSide
3 Connector Pins See Table Below
4. I/O Circuit See Table Below
5. Level RS-232C
6. Cable Cross(Reverse)Cable
PinNo. SignalName I/O Functions
1 NC
-
Not Connected
2 RXD Input Reception Data
3 XD Output Transmission Data
4 DTR Output Data Terminal Ready
5 GND
-
Ground for Signal
 6 DSR Input DataSetReady(NotDetected)
7 RTS Output Transmission Request
 8 CTS Input TransmissionReady(NotDetected)
9 NC
-
Not Connected

APPENDIX