INSTALL UPPER GUIDE RODS:
1.Take (2) Ø25mm Guide Rods (PN:731-2392) and the Upper Bearing Weldment (PN:731-2349-XX) from the packaging.
2.You will use (4) Spacer rings (PN:731-2395), (4) m10 x 25 Hex Head Bolts (PN:731-2333), and (4) m10 Large Washers (PN:731-2396), to install the Guide Rods into the upper mounts. Use a 17mm box wrench to install one bolt washer and space into one end of each rod. Slide the rods through the front mounts taking care not to scratch rods. With the rods through the first mounts now slide the Bearing Weldment (PN:731-2349-XX) over the rods (the larger hole at the ends of the weldment should be facing down), NOTE: DO NOT force the bearing onto the rods this may damage the bearings. Once the Bearing Weldment is on both rods, slide the rods through the back mounts.
3.Take 2 spacers, washers, and bolts, install them on the other end of the Guide rods. Using (2) 17mm box wrenches tighten the fasteners.
INSTALL BEARING MOUNTS TO BAR:
1.Take the (2) Bearing Mounts (PN:731-2385-XX) from the packaging.
2.Using (4) m10 x 35 Hex Head Bolts (PN:731-2399), (8) m10 Washers (PN:731-2419), and (4) m10 Nyloc Nuts (PN:731-2420), install the weldments to the bar. NOTE: the weldments install to the outside of the bar flange
