![](/images/new-backgrounds/1322076/32207637x1.webp)
INSTALL THE LOWER GUIDE RODS:
1.Take the (2) Ø30mm Guide Rods with threaded holes at both ends
2.You will use (4) Spacer rings
3.Take one of the “T” shaped Bearing Weldments, and one of the Rubber Bumpers and slide them over the end of one of the vertical rods (See Below). Now slide the horizontal Guide Rod through the bearings of the “T” shaped Bearing Tube. NOTE: DO NOT force the bearing onto the rods this may damage the bearings. Once the Bearing Weldment is on the rods, slide the rod through the back mount.
4.Take 2 spacers, washers, and bolts, install them on the other end of the Guide rods. Using (2) 16mm box wrenches tighten the fasteners.
Page 19