Star Trac UB Sport Upright Bike manual Sport Recumbent Bike Assembly and Setup, Unpacking

SPORT RECUMBENT BIKE ASSEMBLY AND SETUP

Use the following procedures to unpack and assemble your STAR TRAC

SPORT UB / UBx RECUMBENT BIKE.

UNPACKING

NOTE: Complete unpacking instructions are printed on the side of the shipping carton.

Turn the shipping carton upside-down, and fully open all four flaps on the bottom of the carton.

Turn the shipping carton right-side up, then lift the carton off of the foam inserts. Remove all parts and foam inserts, and verify that the following parts are included in your shipment:

Description	Qty
Bike Frame	1
Display Console Assembly	1
Seat Frame Assembly	1
Front Foot	1
Rear Foot	1
Pedals (set of two)	1
Screw, Button Head, M10 X 30	8
Screw, Flat Head, M6 X 16	4
Screw, Socket Head, M6 X 20	4

TOOLS REQUIRED

Most STAR TRAC bikes can be assembled using the following tools:

■	Metric Hex Key Wrenches	■	Channel Lock Pliers
■	Metric Open-End Wrenches	■	Vice Grip Pliers
■	Metric Ratchet Socket Wrench Set	■	Rubber Mallet
■	Torque Wrench	■	Phillips Head Screwdriver

Your STAR TRAC UB / Ubx SPORT RECUMBENT BIKE includes a hex key set and combination open-end wrench.

ASSEMBLY

1. Install the Front Foot

NOTE: The front foot assembly has wheels attached to the front edge. Be sure the wheels face forward when installing the front foot assembly.

Stand the bike frame upright and place the front foot assembly under the frame, aligning the holes in the foot with the holes in the frame.

NOTE: It may be necessary to raise the frame slightly to align the holes in the frame with the mating holes in the front foot.

Using four M10 X 30 button head screws, secure the front foot assembly to the frame. Tighten all four screws securely.

Step 1

14 STAR TRAC SPORT BIKES OWNER’S MANUAL